Allied Telesis AT-S94 User Manual
Page 141
Configuring Spanning Tree
Configuring Rapid Spanning Tree
Page 141
To define RSTP on the device:
1.
Click Layer 2 > RSTP. The RSTP Page opens:
Figure 93: RSTP Page
The RSTP Page contains the following fields:
•
Select the interfaces displayed in the table.
–
Ports of Unit — Specifies the port and stacking member for which the RSTP settings are displayed.
–
Trunks — Specifies the trunk for which the RSTP settings are displayed.
•
Interface — Displays the port or trunk on which Rapid STP is enabled.
•
Role — Displays the port role assigned by the STP algorithm to provide to STP paths. The possible field
values are:
–
Root — Provides the lowest cost path to forward packets to the root switch.
–
Designated — The port or trunk through which the designated switch is attached to the LAN.
–
Alternate — Provides an alternate path to the root switch from the root interface.
–
Backup — Provides a backup path to the designated port path toward the Spanning Tree leaves. Backup
ports occur only when two ports are connected in a loop by a point-to-point link, or when a LAN has two
or more connections to a shared segment.
–
Disabled — The port is not participating in the Spanning Tree.