Adding log servers – Allied Telesis AT-S94 User Manual
Page 130
Page 130
Allied Telesis
AT-S94 Management Software Web Browser Interface User’s Guide
The Configure Log Outputs table displays the following log information:
•
Type — Indicates the log type included in the output. The possible values are:
–
Console — Indicates that the output is of a console log.
–
Temporary — Indicates that the output is of the temporary memory log. Temporary logs are not available
after reset.
–
Flash — Indicates that the output is of a Flash memory log. Flash logs are available after reset.
•
IP Address — Displays the defined IP address of the syslog server.
•
Minimum Severity — Indicates the defined minimum severity level.
•
Description — Provides additional information about the syslog server.
Clearing Event Logs
To clear all events from the log:
1.
Click System > Event Log. The
Event Log Page opens:
2.
Click Clear Logs. The stored logs are cleared. If logging is enabled, the system begins to log new events.
Adding Log Servers
To add a log server:
1.
Click System > Event Log. The
Event Log Page opens.
2.
Select a Log Type in the Configure Log Outputs table.
3.
Click Add. The Add Syslog Page opens:
Figure 87: Add Syslog Page