Allied Telesis AT-S94 - Manual (Page 165)

Configuring SNMP
Page 165
The Add SNMP Community Page contains the following fields:
• Supported IP Format — Indicates the supported Internet Protocol on the device. The possible field values
are:
– IPv4 — Indicates that IPv4 is supported.
– IPv6 — Indicates that IPv6 is supported.
• IPv6 Address Type — Defines the type of configurable static IPv6 IP address for an interface. The possible
values are:
– Link Local — Defines a Link Local address; non routable and can be used for communication on the
same network only. A Link Local address has a prefix of 'FE80'.
– Global — Defines a globally unique IPv6 address; visible and reachable from different subnets.
• Link Local Interface — Indicates the type of Link Local interface. The possible values are:
– VLAN 1
– Tunnel 1
• SNMP Management Station’s IP Address — Displays the management station IP address for which the
advanced SNMP community is defined. A value of 0.0.0.0 indicates all management station IP addresses.
• Community String — Defines the community name used to authenticate the management station to the
device.
• Basic or Advanced mode.
• Access Mode — Defines the access rights of the community. The possible field values are:
– Read Only — Management access is restricted to read-only, and changes cannot be made to the
community.
– Read Write — Management access is read-write and changes can be made to the device configuration,
but not to the community.
– SNMP Admin — User has access to all device configuration options, as well as permissions to modify
the community.
• View Name — Contains a list of user-defined SNMP views in addition to the Default and DefaultSuper views
• Group Name — Indicates the group that was assigned to the community.
3. Define the fields.
4. Click Apply. The SNMP community is added, and the device is updated.
5. Click Save Config on the menu to save the changes permanently.