Allied Telesis AT-TQ3600 - Manual (Page 50)

Chapter 2: Installing the Access Point
50
Installing Anti-theft Devices
The access point has holes for anti-theft devices. Refer to Figure 25. You
may want to install one or more anti-theft devices if the access point is
installed in a non-secure area.
Note
Anti-theft devices are not available from Allied Telesis.
Figure 25. Holes for Anti-theft Devices
A padlock or Torx screw can be used to secure the access point to the
bottom panel when it is installed on a wall or ceiling. A Kensington lock
can be used to secure the device when it is installed on a wall, ceiling, or
table.
Kensington
Lock Torx or similar screw
(M3 x 4mm) Padlock