Allied Telesis AT-TQ3600 - Manual (Page 49)

AT-TQ3600 Wireless Access Point Installation Guide
49
10. Check the AC plug on the AT-TQ0091 AC/DC Power Adapter to see if
it is the correct plug for your region. If it is not the correct plug, remove
it by pushing down on the release tab and sliding it from the slot on the
adapter. Refer to Figure 6 on page 31.
11. Slide the correct plug for your region into the slot on the adapter until it
clicks into place. Refer to Figure 7 on page 32.
12. Connect the adapter to an appropriate AC power source. Refer to
Table 7 on page 58 for the power specifications of the power adapter.
After installing the access point on a wall or ceiling, go to “Installing Anti-
theft Devices” on page 50 or “Starting the Initial Management Session on
the Access Point” on page 51.