Allied Telesis AT-TQ3600 - Manual (Page 30)

Chapter 2: Installing the Access Point
30
Figure 4. Connecting the Network Cable for Table or Desktop Installation
4. If you have not already done so, connect the other end of the network
cable to a port on an Ethernet switch.
5. Do one of the following:
 If the access point is to be powered with the AT-TQ0091 AC/DC
Power Adapter, continue with this procedure to attach the power
adapter.
 If the access point is to be powered with the PoE feature on the
LAN Port, turn the access point right side up. The installation
procedure is complete. Go to “Installing Anti-theft Devices” on
page 50 or “Starting the Initial Management Session on the Access
Point” on page 51.
6. Route the DC power cable from the AT-TQ0091 AC/DC Power
Adapter through the notch in the cover and under the bottom panel,
and connect it to the DC-IN connector on the access point. Refer to
Figure 5 on page 31.