beautypg.com

Figure 24: tightening the captive screw – Allied Telesis AT-TQ3600 User Manual

Page 48

background image

Chapter 2: Installing the Access Point

48

Figure 24. Tightening the Captive Screw

7. Close the front panel.

8. If you have not already done so, connect the network cable from the

wireless access point to a port on an Ethernet switch.

9. Do one of the following:

If the access point is using PoE, the installation is complete. Go to
“Installing Anti-theft Devices” on page 50 or “Starting the Initial
Management Session on the Access Point” on page 51.

If the access point is using the AT-TQ0091 AC/DC Power Adapter,
perform the rest of this procedure to check and, if necessary,
change the AC plug on the adapter.

See also other documents in the category Allied Telesis Computer hardware: