Campbell Scientific PS200/CH200 12 V Charging Regulators User Manual

Page 49

Text mode
Original mode

PS200/CH200 12 V Charging Regulators

Click on OK, and then set the COM port settings:

Click on Apply and then OK, and the terminal screen should open. Click
inside the terminal screen and press ESC (may have to press ESC twice).

To refresh the charger status screen, press ESC.

To change the SDI-12 address of the PS200/CH200, press 1 and then Enter.

Also, as shown in Section 6.2.2, SDI-12 Measurements, the PS200/CH200
RS-232 text based interface can be viewed from within Campbell Scientific
DevConfig.