Campbell Scientific PS200/CH200 12 V Charging Regulators - Manual (Page 30)

PS200/CH200 12 V Charging Regulators
When the user clicks on the Connect button, the device type, serial port, and
baud rate selector controls become disabled and, if DevConfig is able to
connect to the PS200/CH200, the button will change from “Connect” to
“Disconnect”. The Display will change to:
6.1.2 Settings Editor Tab
Not all settings can be changed. Grayed out fields cannot be changed. To
change a setting, select the field to be changed, type in a new value and press
Enter. If the value entered is not within an acceptable range, a message in red
lettering will appear to the right of the entered value. Real time values can be
viewed while in this screen. These values are updated every second.
An example of an incorrect value entered in for the continuous charging source
current is shown below.
22