Campbell Scientific PS200/CH200 12 V Charging Regulators - Manual (Page 35)

PS200/CH200 12 V Charging Regulators
TABLE 6-1. PS200/CH200 Settings
Battery
Current
Offset. Not
user
adjustable. Calibration offset for battery current measurement. “Factory Defaults” button does not affect
calibration values.
Load Current
Offset. Not
user
adjustable. Calibration offset for load current measurement. “Factory Defaults” button does not affect
calibration values.
Battery
Current
Multiplier.
Not user
adjustable. Calibration multiplier for battery current measurement. “Factory Defaults” button does not
affect calibration values.
Load Current
Multiplier.
Not user
adjustable. Calibration multiplier for load current measurement. “Factory Defaults” button does not affect
calibration values.
Digital
Potentiometer
K Value. Not
user
adjustable. K calibration value for charge voltage control by means of digital potentiometer. DPOT =
K/VTARG-L.
“Factory Defaults” button does not affect calibration values.
Digital
Potentiometer
L Value. Not
user
adjustable. L calibration value for charge voltage control by means of digital potentiometer. DPOT =
K/VTARG-L.
“Factory Defaults” button does not affect calibration values.
Press F5 to refresh the Settings Editor.
6.1.2.1 Battery Families
The PS200/CH200 has charging algorithms built in to handle the
EnerSys/Genesis NP series of batteries (CS models PS200, BP12, and BP24),
EnerSys/Genesis Cyclon Series, Concorde Sun Xtender (BP84), or custom
algorithms entered in by the user. The PS200/CH200 uses a second order
polynomial to make the correct battery charging adjustments for known battery
families and charging cycles. Click on the down arrow to the far right of
“Battery Family” to access the drop down menu of battery families. See
FIGURE 6-2.
27