Right), 2. pn 28902 csat3 sonic wick spares kit contents – Campbell Scientific IRGASON Integrated CO2/H2O Open-Path Gas Analyzer and 3D Sonic Anemometer User Manual

Page 36

IRGASON

Integrated CO

O Open-Path Gas Analyzer and 3D Sonic Anemometer

Wick Spares Kit (pn 28902) consists of three top wicks, three bottom wicks,

adhesive, and an installation tool (see FIGURE 9-2). The installation tool is

used by placing a wick over the angled end of the tool, placing the straight end

of the tool gently against the transducer face, and sliding the wick down the

tool onto the transducer. When installing wicks, be sure they are located in the

proper position. The top wick must be flush with the transducer face, with the

wick tail located at the lowest point of the transducer (see FIGURE 9-1). The

end of the bottom transducer wick must extend above the transducer face by

one-half to one mesh line (see FIGURE 9-1). Secure the wicks to the

transducer with a drop of adhesive which is provided in the CSAT3 Sonic

Wick Spares Kit (pn 28902). Take care that the adhesive is not deposited on

the transducer face.

FIGURE 9-1. Proper location of the sonic top wick (left)

and bottom wick (right)

FIGURE 9-2. PN 28902 CSAT3 Sonic Wick Spares Kit contents