Campbell Scientific CDM-VW300 Series Dynamic Vibrating-Wire Analyzer System - Manual (Page 44)

CDM-VW300 Series Dynamic Vibrating-Wire Analyzers
Setting Description
DVWTool PC Software
Setting Name
DevConfig PC Software
Setting Name
CRBasic Datalogger
Instructions /
Parameters
Multiplier Multiplier Multiplier
CDM_VW300Config()
Mult
Offset Offset Offset
CDM_VW300Config()
Offset
Steinhart-Hart
coefficients Steinhart-Hart
Thermistor Coeff A
Thermistor A
CDM_VW300Config()
SteinA
Steinhart-Hart
Thermistor Coeff B
Thermistor B
CDM_VW300Config()
SteinB
Steinhart-Hart
Thermistor Coeff C
Thermistor C
CDM_VW300Config()
SteinC
Rainflow-histogram
output configuration Rainflow | Number of
Mean Bins
Rainflow Mean Bins
CDM_VW300Config()
RF_MeanBins
Rainflow | Number of
Amp Bins
Rainflow Amp Bins
CDM_VW300Config()
RF_AmpBins
Rainflow | Low Limit Rainflow Low Limit
CDM_VW300Config()
RF_LowLim
Rainflow | High Limit Rainflow High limit
CDM_VW300Config()
RF_HighLim
Rainflow | Minimum
Change
Rainflow Min Change
CDM_VW300Config()
RF_Hyst
Rainflow | Rainflow Form Rainflow Form
CDM_VW300Config()
RF_Form
7.5.1 Device Name
This setting specifies an alphanumeric name for the analyzer. This is an
optional setting and is not available in the CRBasic datalogger instruction
setup.
7.5.2 CPI Bus Speed
This setting specifies the speed at which the CDM-VW300 communicates with
the CPI bus. Speed options are 50, 125, 250, 500, and 1000 kbps. In a
CRBasic program, use the CPISpeed() instruction to set this setting. Shorter
CPI cable lengths allow for a faster CPI bus speed.
34