beautypg.com

Flytec 6030-gps, 4 factory settings (specific instrument settings), 4 data transfer – Flytec 6030 * User Manual

Page 38

background image

Flytec 6030-GPS

38 / 62





3.3 Manage

Memory


Delete all flights

Deleting the entire flight memory.
This command reformats the flight
memory, all the other settings are not lost.

no

Delete all WPs &
Routes

Deleting all WPs and Routes

3.3,
3.4

no

Delete all Airspace
CTR data

Reorganisation of the Memory Zone for
the CTR’s

2.11

Format
Memory

Reset of Basic values to factory setting

3.1

no

Caution

: When deleting WPs, Routes or flights, the deletion process takes a couple of

seconds, please wait during this time span.


3.4 Factory

Settings

(Specific instrument settings)


This default value, which is not accessible to the pilot, contains all basic settings of the
instrument. In particular, both the sensor specific parameters and all calibration data are
located here. These data are not lost, even when the power supply is switched-off.

4 Data

transfer

All data entered by the pilot, including Waypoints, Routes, pilot’s name, etc. as well as the
automatically recorded track log points of the flights undertaken by him are in the memory of
the FLYTEC 6030 GPS.
Each of these track log point contains the time, position, GPS altitude, barometric altitude as
well as the flight speed. In this way, it is possible to graph the Barogramm, variogram, speed
gram and course of the flight on a Map for later evaluation.
These data are processed for flight analysis by various evaluation programs. In Flychart 4.52
it is possible to show the flight on the PC monitor in 3D on a realistic landscape on Google
Earth.



4.1 Flight-Memory and Flight-Analysis


The recording mode does not need to be specifically activated, as each flight is automatically
saved. The flight memory used in the FLYTEC 6030 GPS not only records flight altitude and
flight speed TAS, but it also logs, under condition of good GPS reception, the position of the
pilot in the WGS84 co-ordinate system and the GPS altitude. The value set in Set-Mode under
record-Interval determines the time interval counted in seconds, after which a new data set
is entered into the FLYTEC 6030 GPS memory.