Flytec 6030 * - Manual (Page 36)

Flytec 6030-GPS
36 / 62
charging has been completed. If one keeps the charger connected to power supply for a
couple of hours after extinction of the LED, then the energy stored in the accumulator shall
be increased by a few more percent by trickle mode.
Caution:
during charging the outside temperature should be between + 5 °C and + 35 °C.
It is possible to check during charging the accumulator’s voltage, however, the FLYTEC 6030
GPS
should be switched-off during charging.
3
The Setting Menus
Prolonged pressing of the OK/Menu key gives access to the setting mode. With the ▼ key
one of the menu items is selected and pressing the OK key gives access to the relevant
subdirectory.
3.1 User Settings
A series of settings allow the instrument to be programmed in accordance to the user’s
wishes. Every pilot may realise his very own ideas here. All the basic settings may be
set comfortably on the PC by use of the PC-Software „Flychart“ and be transferred later
to the instrument via the PC interface. Manufacturer’s approved basic settings are called-up
with
Basic Settings / Init EEPROM. Please note to use this setting only in case of emergency,
because hereby all WPs and Routes shall be erased. In most cases the possible setting
range and its value valid previously is indicated individually for each of the settings. If this
value should be modified, pressing of the OK key gives access to change mode, the
value to be modified will blink and can now be changed by use of the ▼ and ▲ keys.
Pressing the OK key confirms the new value, pressing of the ESC key recalls the previous
setting.
Term Denotation
More Factory setting
Variometer info
Ground filter
Diagnose of time constant f. Vario a.
Speed 1.1 12 ( ≈ 1,2 sec)
Digital Vario
Integrator Shift Integr.- Netto-Vario; Integr.-time
constant 1.3 Integr. 1 30 sec
1 sec
Threshold last climb Threshold for the last climb
Day specific climb Time constant for the time-average of
specific climb during this day 1.11 0,5 ...10 min
10 min
Variometer
Acoustic
Acoustics settings Climb tone frequency, modulation; sink
tone freq., Acoustic dampening;
Pitch 1.7 1200 Hz; Mod = 5,
700 Hz, 8, Pi = 3
Climb acoustic,
activation threshold Fine tuning of climbing tone,
max. 20 cm 2 cm/sec
Sink tone act.
threshold Activation point of Sink tone 1.7 0,8 m/s (ft/m)
Speed
Speed mode True or Indicated Airspeed 5.3 0 = true airsp.