Flytec 6030 * - Manual (Page 23)

Flytec 6030-GPS
23 / 62
observe a start time and the automatic switch over to the next WP is effected as soon as the
pilot is inside the cylinder.
If however in a competition a start cylinder is predetermined, the valuation starts as soon as
the start time is reached under these conditions:
Startmode EXIT:
if the pilot is inside the cylinder and start time has been reached
Startmode ENTER: if the pilot den crosses the start cylinder from outside to inside
Task: EXIT Cylinder
The „WP reached“ signal will be given as soon as the start time is reached and the
pilot is inside the start cylinder. It will also sound if the start time is positive and the pilot
crosses the start cylinder circumference from outside to inside. In both cases the next active
waypoint will be enabled, in this case WP2. All calculations and the direction arrows are now
related to WP2 and the next turnpoint will become active (in this case WP2). All calculations
and the direction arrows are now with respect to WP2.
If the pilot decides to take the next start gate, he must press the Prev WP ▼ key. (Select
this Menu with prolonged pressing on McC ; /WP). The instrument then enables WP1 again
and will increment the start time by the preset difference. When the last start gate is reached,
the start time will no longer be increased after pressing of „Prev. WP ▼“.
Caution: for EXIT cylinder it is required that the first waypoint after the start cylinder is
outside of the start cylinder!
Task: ENTER Cylinder
WP1
Exit
WP2
WP3
WP1
ENTER
WP2
WP3