Flytec 6030 * - Manual (Page 29)

Flytec 6030-GPS
29 / 62
If the pilot is inside of the CTR, then Dist. to CTR is always indicated as 0.
For each CTR is assigned a name and a comment to be freely edited by the pilot. The
names of the five next airspace CTR’s may be shown with the Map Mode key. The
comment may be used to inform the pilot during flight about the upper or lower border limits
of the CTR. The sequence of these CTR’s corresponds to the distance from the momentary
position. A second pressing on the Info/Htwind key removes this information.
We invite pilots who want to make use of CTR’s to contact us. They will get, dependent on
the serial no. of the FLYTEC 6030 GPS, a 5-digit activation code for entry into the
instrument.
Procedure for entry of activation code:
Setup Menu / Optional SW-Packages - OK
Set marking on CTRs (Restr. Areas) ▼ - OK
Enter activation code ▼ ▲ - OK. One starts best with the ▼ arrow.
If the code number was correct, the instrument confirms with : Package released
2.6.10 Air space - enter – alter - Delete
The Menu Airspace is placed in Main Menu -> Airspace.
As type the following elements may be selected:
Point:
endpoint
Centre: centre of arc segment
Startboarder: start point of arc segment
Stopboarder: endpoint of arc segment
Circle: centre of the circle plus Radius
Restricted areas
=====================
CTR1 Alpnach
TMA 1 Alpnach
TMA 2 Alpnach
=====================⇓
Ctr1/3
CTR 1 Alpnach
Höhe FL130
Warning Dist.[m]: 200
No Elements:8
Ins Del
Ctr Ctr
Name of CTR
Personal comment
Information to
number of end
points / elements
Warning distance