Flytec 6030 * - Manual (Page 13)

Flytec 6030-GPS
13 / 62
Pitch
Beep interval
See graphic. The beep interval is also called „Pitch“.
Factory setting = 3
0 2 4 6 8 10 12 14
5
10
15
20
25
30
Pitch
Frequenz
Hz
Vario (m/s)
Piepsintervall - lang
Piepsintervall - kurz
In Set-Menu „Basic Settings“ the following threshold settings may be entered:
Sink tone threshold.
Starting point
The starting point of sink acoustic can be selected just as in
climb acoustic.
Vario Audio threshold,
Starting point
In order to avoid the climb acoustic get started on the ground
with immobile aircraft, for ex. at take-off area, the acoustic
starting point can be set in the range from 0.02m/s up to 0.2m/s.
The warning sound for Stall alarm is a pitch tone of medium height with a very fast interval rate
and always at full volume level of 100%. (Please also read Stall-alarm chapter 2.3.3 page 15)
When gliding with McCready sound activated, the tone to be heard is corresponding to the
active McCready locator. Because of the pulse/pause ratio being here 1:4, it is not possible
to confound this sound with the vario ascent tone.
(Please read 0 - Travel optimised Speed to Fly acc. to McCready).
The warning tone for negative McCready-Ring values is a deep tone with rapid
interval rate which tells the pilot: „fly faster immediately“.
All types of sound effects described here above may be heard in simulation mode.
=7
=1