Flytec 6030 * - Manual (Page 37)

Flytec 6030-GPS
37 / 62
Pitot Sensor setting Correction of pressure sensor -
90 .. 150 % - Use Sensor 1.4 100 %
Yes
Sensor setting Wind
vane Correction wind vane 70 ... 150 % 1.4 100 %
Stall Speed Activation of Stall alarm a. altitude limit 1.6,
5.1 0 km/h (mph)
TEC Total-Energy-Compensation 5.7 65 %
Airspeed offset This speed difference is added to actual
value of air pressure speed. This Offset
has the purpose to compensate for steady
surrounding air below the wing.
If settings are made here, one should
decrease the Airspeed correct pitot by a
few percent. 0
Flight memory
Recording
Auto/Man. Autom. or manual Flight recording 3.2 Aut.
Recording interval
Time interval per recording point - 2 to 30
seconds 3.2 10 Sec
McCready
Tone gap Time delay for McCrd after climb
Acoustic tone gap in +/- xx cm/s 1.10 7 Sek.
30 cm/s
Polardata Two Polar values 1. at min. sink and 2. at
high speed. for two different aircraft 5.4 40 km/h at 1m/s
76 km/h at 3m/s
Pilot name
Entry of pilot’s name; max. 25 characters not set
Glider type
Name of aircraft for OLC not set
Glider-Id
Ident. No. of aircraft for OLC not set
the word “threshold” has the denotation “threshold resp. activation point“
3.2 Instrument
Settings
Bezeichnung Bedeutung
mehr Werkseinstellung
dazu
Display contrast Range 0 .. 100 % 70 %
Language Selection possible from 5 different
languages 1) English
Battery type Battery type. Selectable between Alcaline
or NiMH 1) Alcaline
Time zone Difference to UTC; 0.5h time zones may
also be set -2
Units Meter or feet; Km/h or mph or knots.
Temp. In °C or °F m ; km/h ; °C
Coordinate format dd'mm.mmm or dd.ddddd or dd'mm"ss
UTM or Swiss-Grid dd'mm.mmm
Bluetooth Only active when SW Package Bluetooth
is activated. Here is made the Pairing of
Bluetooth interface for the SMS function.
SMS only active, when Bluetooth and SMS SW
Package is activated. Here is entered the
target telephone number and the Mode.
Additional Software
packages Here additional SW Functions (Packages)
are activated. For this purpose the relevant
manufacturer’s Code is required.
Factory Settings Disabled Zone