Videotec ULISSE COMPACT - Manual (Page 57)

Instruc
tions manual - English - EN
57 MNVCUCZ_1351_EN
11.7 Recalling the Home position
Using the control device it is possible to recall a
previously saved Home (Scan n.1) position (for further
information refer to the manual of the control device
in use).
11.8 Enabling the wiper (Wiper)
Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
To enable/disable the wiper refer to the manual of
the control device in use or to the relative table (11.13
Special controls, page 58).
If it is left on, the Wiper automatically
disables itself.
11.9 Enabling the washer
(Washer)
To activate refer to the manual of the control device
used or the relevant chapter (11.13 Special controls,
page 58).
Once the command has been sent the pan & tilt
positions itself with the glass facing the nozzle. The
pump and wiper are activated for a set period of time.
At the end of the operation the P&T returns to its
initial position.
For models with washer complete with level sensor,
can also display a video message when the level of
the liquid inside the tank is too low (only if using a
high prevalence pump).
11.10 Enabling the LED
illuminator
The system may not be equipped with photocell and
the automatic activation through the module may
not be enabled (9.1.9.11 Advanced Setting Menu
(Infrared), page 36). LED lighting may be activated/
deactivated through the specific control (11.13
Special controls, page 58).
If it is left on, the LED Illuminator
automatically disables itself.
11.11 Reboot the device
Using the control device it is possible to reboot the
unit. For further information refer to the manual of
the control device in use or to the relative table For
further information refer to the relative chapter (11.13
Special controls, page 58).
11.12 Manual correction of a
preset focusing
Load the preset whose focus needs to be changed
using the Scan command. Change the focus using
the appropriate keys Focus Far/Focus Near without
changing the Pan/Tilt/Zoom position. Save the preset
using the appropriate Preset command.
The manual correction of the Preset works
only if the Daytime/Nigh-time Autofocus
fields are disabled (9.1.10.5 Preset Menu
(Utilities Configuration), page 40).