Red Lion PAX2C - Manual (Page 16)

16
RESET MAXIMUM DISPLAY
When activated (momentary action), rSEt flashes and
the Maximum resets to the present Input Display value.
The Maximum function then continues from that value.
This selection functions independent of the selected
display.
SELECT MINIMUM DISPLAY
The Minimum display appears on Line 2 as long as activated
(maintained). When the user input is released, the previously selected
display is returned. The D or P keys override and disable the active
user input. The Minimum continues to function independent of the
selected display.
RESET MINIMUM DISPLAY
When activated (momentary action), rSEt flashes and
the Minimum resets to the present Input Display value.
The Minimum function then continues from that value.
This selection functions independent of the selected
display.
RESET MAXIMUM AND MINIMUM DISPLAY
When activated (momentary action), rSEt flashes and
the Maximum and Minimum readings are set to the
present Input Display value. The Maximum and Minimum
function then continues from that value. This selection
functions independent of the selected display.
RESET ALARMS
When activated (momentary action), the controller will
reset any active alarms that are selected in the User/
Function Alarm Selection Menu (ASEL).
Basic Mode: 4 Alarms Max
Advanced Mode: 16 Alarms Max
ALARM MASK SELECTION
Selects the alarms that will be reset when the User Input/
Function keys are activated. Any alarms configured as “YES”
will be reset depending on the alarms configuration. Please see
the Alarms section of the manual for more information on the
alarm reset operation.
ADJUST DISPLAY INTENSITY
When activated (momentary action), the display
intensity changes to the next intensity level.
DISPLAY SELECT
When activated (momentary action), Line 2 advances
to the next display that is not locked out from the Display
Mode.
SELECT PARAMETER LIST
Two lists of input scaling points and alarm values
(including band and deviation) are available. The two lists
are named LStA and LStb. If a user input is used to select
the list then LStA is selected when the user input is not
active and LStb is selected when the user input is active
(maintained action). If a front panel key is used to select
the list then the list will toggle for each key press
(momentary action). The display will only indicate which list is active when the
list is changed. To program the values for List-A and List-B, first complete the
programming of all the parameters. Exit programming and switch to the other
list. Re-enter programming and enter the desired values for the input scaling
points, alarms, band, and deviation if used.
PRINT REQUEST
The meter issues a block print through the serial port
when activated, and the serial type is set to rLC. The data
transmitted during a print request and the serial type is
programmed in Module 7. If the user input is still active
after the transmission is complete (about 100 msec), an
additional transmission occurs. As long as the user input
is held active, continuous transmissions occur.
USrn
FNC
r-HI
Fn
FNC
r-HI
USrn
FNC
d-Lo
USrn
FNC
r-Lo
Fn
FNC
r-Lo
USrn
FNC
r-HL
Fn
FNC
r-HL
USrn
FNC
r-AL
Fn
FNC
r-AL
ASEL
Un
NO
An
USrn
FNC
dLEU
Fn
FNC
dLEU
USrn
FNC
dISP
Fn
FNC
dISP
USrn
FNC
LISt
Fn
FNC
LISt
USrn
FNC
Prnt
Fn
FNC
Prnt