Vaisala PTU200 - Manual (Page 30)

U SER ' S G UIDE _______________________________________________________________________
26 ___________________________________________________________________ M210195 EN -A
R Starting the continuous output
R
This command is used to start continuous outputting in the STOP and
RUN modes and after setting the output interval (see page and 18).
Example (in STOP mode):
>reset
PTU200 / 1.01
>r
1013.25 hPa 22.9 %RH 22.4 'C
1013.25 hPa 22.9 %RH 22.4 'C
1013.25 hPa 22.) %RH 22.4 'C
...
Example of restarting the outputting (in RUN mode):
>SMODE
Serial mode
: RUN
>RESET
1009.1 hPa 42.4 %RH 24.2 'C
1009.1 hPa 42.4 %RH 24.2 'C
...
S (
text invisible)
>R
1009.2 hPa 42.5 %RH 24.2 'C
1009.1 hPa 42.5 %RH 24.2 'C
...
S Stopping the output
S
This command is used to stop the continuous outputting (activated
with power-up or reset in RUN mode or using the R command).
Example:
>r
1013.25 hPa 22.9 %RH 22.4 'C
1013.25 hPa 22.9 %RH 22.4 'C
1013.25 hPa 22.9 %RH 22.4 'C
s
(text invisible)
>