Vaisala PTU200 - Manual (Page 16)

U SER ' S G UIDE _______________________________________________________________________
12 ___________________________________________________________________ M210195 EN -A
Software settings
SERI Serial bus settings
SERI b p d s x
where: (* = factory setting)
b
= baud rate (300...9600*...38400)
p = parity (E = even*, O = odd, N =
none)
d = data bits (7* or 8)
s = stop bits (1* or 2)
x = duplex (F = full* or H = half)
= carriage return is generated by the
ENTER or RETURN key of the
host computer
The SERI command is used to set or inspect the serial bus settings of
the transmitter.
Examples:
>seri
9600
E 7 1 F
>seri 1200 N 8 1 H
1200
N 8 1 H
>reset
PTU200 / 1.01
>
NOTE Always give the RESET command after the SERI command to
activate the new serial bus settings.
ECHO Setting the serial bus echo on/off
ECHO x
where:
x = ON or OFF
The ECHO command can be used to set or inspect the echoing
condition of the transmitter. In OFF mode the transmitter does neither
output the '>' prompt character nor echo the given commands.