Vaisala HMP230 User Manual
Uide
Table of contents
Document Outline
- APP1.pdf
- 1. ANALOGUE OUTPUT COMMANDS
- 2. CALIBRATION COMMANDS
- 3. OUTPUT VIA THE SERIAL BUS
- R Starting the measurement output
- S Stopping the measurement output
- SEND Outputting a reading once
- DSEND Outputting readings of all connected transmitters once
- ERRS Outputting error messages
- ECHO Turning the serial interface echo ON/OFF
- INTV Setting the output interval for the RUN state
- FORM Setting the output format
- FTIME Adding time to output
- FDATE Adding date to output
- SERI Serial bus settings
- UNIT Selecting the output units
- ADDR Setting the transmitter address
- FROST Setting the calculation mode
- RESET Resetting the transmitter
- 3.1 Operation modes
- 4. OTHERS
- ITEST Testing the analogue outputs
- FILT Setting the averaging time
- PRES Setting the pressure for pressure compensation of the HUMICAP( sensor and for mixing ratio, wet bulb temperature and enthalpy calculations
- XPRES Setting the pressure for pressure compensation of the HUMICAP( sensor and mixing ratio, wet bulb temperature and enthalpy calculations tempo˜rarily
- CDATE Entering calibration date
- DATE Setting the date
- TIME Setting the time
- VERS Name and version of the programme
- ? Outputting the transmitter settings
- ?? Outputting the transmitter settings also in POLL mode
- APP2.pdf
- APP3.pdf
- APP4.pdf
- APP5.pdf
- APP7.pdf
- APP8.pdf
- APP9.pdf
- APP10.pdf
- App 11.pdf
- Warranty.pdf
- Warranty
- Warranty.pdf