Outback Power Systems FLEXmax Extreme Owners Manual - Manual (Page 69)

Specifications
900-0150-01-00 Rev A 67
Table 10 FLEXmax Settings (MATE3)
Mode Menu Item Setting
Auxiliary Output
Diversion:Solid St
Default
Relative Voltage
Default 0.0 Vdc
Range: 0.0 to 5.0 Vdc
Hysteresis
Default 0.2 Vdc
Range: 0.0 to12.0 Vdc
Hold
Default 0.1 second
Range: 0.0 to 25 seconds
Delay
Default 0.0 seconds
Range: 0.0 to 24 seconds
Low Batt Disconnect
Default
Disconnect
Default 13.6 Vdc
Range: 10 to 80 seconds
Reconnect
Default14.4 Vdc
Range: 10 to 80 seconds
Disconnect Delay
Default 01 second
Range: 0 to 250 seconds
Remote
Default
Vent Fan
Default
Enable Voltage
Default 14.4 Vdc
Range: 10. 0 to 80.0 Vdc
PV Trigger
Default
Active
Default Active High
Range: Active High or Active Low
Enable Voltage
Default 140 Vdc
Range: 20 to150 Vdc
Hold Time
Default 01.1 second
Range: 0 to 25 seconds
Error Output
Default
Low Battery Voltage
Default 11.5 Vdc
Range: 10 to 80 Vdc
Night Light
Default
Active
Default Active High
Range: Active High or Active Low
Threshold
Default 010 Vdc
Range: 5 to 150 Vdc
ON Time
Default 4 hours
Range: 00 to 23 hours
Hysteresis Time ON
Default 1 minute
Range: 1 to 255 minutes