Outback Power Systems FLEXmax Extreme Owners Manual - Manual (Page 53)

MATE/MATE2 Screens
900-0150-01-00 Rev A 51
METER Screens
Figure 52 METER Screens
Charge Controller METER Screens
The METER screens display readings for power, current, and
voltage handled by the FLEXmax Extreme. They show many
of the same items as displayed on the Status Menu of the
MATE3. See page 30 for descriptions.
mode/pv-in/bat-out:
 mode (charger )
~ Bulk
~ Absorption
~ Float
~ Silent
~ Equalization
charger watts: Charger output to the battery (watts).
charger kwhrs: Kilowatt-hours sent to the batteries today.
charger amps dc: Charger current to the battery (Adc).
battery voltage: Battery voltage (Vdc).
panel voltage: PV array voltage (Vdc).
CC Firmware revision: The level of the last revision or
programming upgrade to the FLEXmax Extreme.
mode: Silent P00
in 11.2 vdc 0 adc
out 14.4 vdc 0 adc
DOWN STATUS PORT
STATUS/CC/METER----P00
charger 0 w
watts
DOWN UP TOP PORT
STATUS----------------
choose device
FX CC DC MAIN
MAIN------------------
1:35:04p
SUM STATUS SETUP ADV
STATUS/CC/PAGE1
MODE METER SETPT PG2
STATUS/CC/METER----P00
charger 0.0 kwh
kwhrs
DOWN UP TOP PORT
Navigation for STATUS/CC/METER
 returns to the CC/PAGE1 screen.
 moves to the next menu item in the diagram.
 moves to the previous menu item in the diagram.
 returns to the first CC/METER screen for the
port shown.
 directs the MATE to read the next device (port)
on the HUB.
STATUS/CC/METER----P00
charger +000 Adc
amps DC
DOWN UP TOP PORT
STATUS/CC/METER----P00
charger 0 ah
amp hour
DOWN UP TOP PORT STATUS/CC/METER----P00
panel 33 Vdc
voltage
DOWN UP TOP PORT STATUS/CC/METER----P00
End of meter menu
UP TOP STATUS
STATUS/CC/METER----P00
battery 13.7 Vdc
voltage
DOWN UP TOP PORT STATUS/CC/METER----P00
CC Firmware revision
002.001.000
DOWN UP TOP PORT
 in vdc (PV array voltage)
 adc (incoming PV current)
 out vdc (battery voltage)
 adc (outgoing current
delivered to the battery)