Outback Power Systems FLEXmax Extreme Owners Manual - Manual (Page 66)

Specifications
64 900-0150-01-00 Rev A
Regulatory Specifications
This product is certified to the following standards:
 UL1741 — Inverters, Converters, Controllers and Interconnection System Equipment for Use With Distributed
Energy Resources — Issue: 2010/1/28 Ed: 2
 CSA C22.2 — General Use Power Supplies, No. 107.1-01 — Issue: 2001/09/01 Ed:3 (R2011)
 AS/NZS 3100:2009 — Approval and Test Specification – General Requirements for Electrical Equipment —
Issue: 2002/05/13
 ROHS: Directive 2011/65/EU — “The restriction of the use of certain substances in electrical and
electronic equipment”
 IEC 61000-6-1 (EMC Standard: Immunity for Residential, Commercial, and Light-Industrial Environments)
 IEC 61000-6-3: 2007; also CISPR 22: 2008 Class B; also EN 55022 (EMC Standard: Emissions for Residential,
Commercial, and Light-Industrial Environments);
 FCC Part 15.109(G): 2012 Class B
This product is CE compliant for all applications.
FCC Information to the User
This equipment has been tested and found to comply with the limits for a Class B digital device when powered
by a DC source, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
~ Reorient or relocate the receiving antenna.
~ Increase the separation between the equipment and the receiver.
~ Consult the dealer or an experienced radio/TV technician for help.
Firmware Revision
This manual applies to FLEXmax Extreme charge controllers with a firmware revision of 001.xxx.000 or higher.
To check the current revision using the MATE3 system display, see page 46.
To check the current revision using the MATE or MATE2 system display, see page 51.
For instructions on updating the firmware revision, see page 46.