Outback Power Systems FLEXmax Extreme Owners Manual - Manual (Page 45)

MATE3 Screens
900-0150-01-00 Rev A 43
Table 6 AUX Mode Functions
Mode Name Function/Purpose Set Points Aux Polarity
Low Battery
Disconnect
Function:
When the battery voltage falls below the
Disconnect voltage following the Disconnect
Delay, the AUX output activates. When the
battery voltage rises above the Re-Connect
voltage, the AUX deactivates.
Purpose:
This mode is intended to turn off “extra” or
noncritical loads when the batteries are low.
This will reduce usage and save battery capacity.
These loads are usually separated from the main
battery loads. They are switched off with a relay
which is controlled by the AUX output.
Any loads not controlled this way may continue
discharging the batteries.
 Disconnect
 Re-Connect
 Disconnect
Delay
Not Available
Remote
Function:
An OutBack system display such as the MATE3
can send external commands to control the AUX
output. (See the system display manual
for details.)
Purpose:
This mode is intended to allow functions such as
AGS to control the AUX output according to
external priorities.
None Not Available
IMPORTANT:
The Remote option allows the MATE3 to use the
AUX output for Advanced Generator Start (AGS).
AGS is intended for systems with a HUB, inverter,
and FLEXmax Extreme. If the MATE3 connects
only to a FLEXmax Extreme, AGS will only work
with DC genset programming. The other AGS
functions will not work properly.
See the MATE3 manual for information on AGS.