HP 3PAR Application Software Suite for Microsoft Exchange User Manual
Page 99
8.9
Recovery Procedures
3PAR Recovery Manager 4.1.0 For Microsoft Exchange 2010 User’s Guide
1
Verify that the database that you want to restore is consistent and that it is in a clean
shutdown state. To do so, open a command prompt, switch to the ExchSrvr\Bin folder, type
the following line, and then press
ENTER
:
In the output that appears in the Command Prompt window, note whether the State line
shows as State: Clean Shutdown or State: Dirty Shutdown.
2
Do one of the following, as appropriate to your situation:
a
If the database is consistent, go to
.
b
If the database is not consistent and if the database log files exist, use the Eseutil.exe
tool to perform a soft recovery on the database. When you perform a soft recovery,
uncommitted logs are committed to the database. To perform a soft recovery, switch to
the ExchSrvr\Bin folder at a command prompt, type the following line, where rnn is the
log file prefix and database_folder_path is the name of the folder where the database
files (
.edb
,
.stm
) are located, and then press ENTER:
For example, you might type the following:
Eseutil /mh YourDatabaseName.edb
NOTE: The following step should have been done after the virtual copy for the
database was created.
eseutil /r rnn /dd
atabase_folder_pa
th
eseutil /r r00
/d"c:\Program Fil
es\Exchsrvr\Recovery Storage Group"
NOTE: There is no space after the /d switch.
NOTE: The following step should have been done after the virtual copy for the
Mailbox Database was created.