HP Surestore NAS - Manual (Page 94)

C-2 Updating the Firmware
Follow the steps below to install new CD-ROM server firmware:
1. Obtain a copy of the firmware update file from your
HP-authorized dealer or from HP’s Electronic Support
services.
2. Log in to the CD-ROM server with the command
ftp
where is the IP address or host
name assigned to your CD-ROM server.
3. You will be prompted for user id and password. The default
user id is
root , and the default password is pass.
( root is the user id with the highest priority).
4. Issue the command bin to change to binary transfer mode.
5. Issue the command put flash where
is the name of the new CD-ROM server firmware, for example
hpcd_411.bin.
CAUTION ❏ Be careful not to interrupt the file transfer. If the
transfer is interrupted the CD-ROM server may
become inoperative and must be returned to HP.
6. Wait for the transfer to complete. This normally takes 1 to 4
minutes. The unit will then automatically restart with the new
CD-ROM server firmware.
7. Log out using the command quit , bye or exit depending on
your FTP version.
Instructions on how to install your CD-ROM server firmware are
also supplied with the firmware update.
hp.book Page 2 Thursday, April 2, 1998 4:33 PM