HP Surestore NAS - Manual (Page 20)

2-8 Basic Installation
1. Connect a SCSI cable to the SCSI connector on the CD-ROM
server and to the first CD-ROM drive.
Connect the SCSI cable to the first CD-ROM drive. If there
are more drives (up to 7), use additional SCSI cables to
connect the drives.
2. Connect a SCSI terminator to the last drive in the SCSI chain:
• If there is only one CD-ROM drive, then it is the “last”
drive in the chain and must be terminated.
• Do not terminate other CD-ROM drives placed between
the CD-ROM server and the last drive.
• The HP CD-ROM
Server contains built-
in SCSI termination;
therefore, the server
must be physically
located at one end of
the chain.
3. Set the SCSI address of
the CD-ROM drive(s).
Each connected drive
must have a unique SCSI
address. SCSI addresses
0 through 6 may be used.
The SCSI address of the
HP CD-ROM Server is 7
and cannot be changed.
See the CD-ROM drive
documentation for
instructions on how to set
the address.
50-pin High-density
(Stand-Alone Module)
SCSI-2 connector
(Tower Module)
50-pin header
SCSI-2 connector
External SCSI Terminator
1
2
hp.book Page 8 Thursday, April 2, 1998 4:33 PM