HP Surestore NAS - Manual (Page 86)

A-10 Troubleshooting
Using a Text
Editor
Follow the steps below to restore the default settings:
1. Locate and open the CD-ROM server’s config.ini file using
a text editor (for example, Windows Notepad).
2. Change the FactoryDefaults parameter from no to yes .
3. Save the file.
This writes the contents of the file to the CD-ROM server and
will reset the server to factory defaults.
Using the Push
Button
Follow the steps below to restore the default settings:
1. Turn off the CD-ROM server (by removing power).
2. Press and hold the Push button while you power on the
CD-ROM server. Continue to press the Push button until the
Network indicator flashes at regular two second intervals.
3. Release the Push button and wait at least two seconds (one
flash of the Network indicator).
4. Press and hold the Push button again for at least five seconds
until the Network indicator remains constantly on.
The CD-ROM server is now reset to factory default settings and
should automatically restart. If it fails to restart, try power
cycling the CD-ROM server.
Push button
(Stand-Alone Module) Push button
(Tower Module)
hp.book Page 10 Thursday, April 2, 1998 4:33 PM