HP Surestore NAS - Manual (Page 22)

2-10 Basic Installation
.
6. Turn power on using the following instructions:
• Stand-alone version only: First connect power to all
CD-ROM drives and turn them on. Then connect the
external power supply to the HP CD-ROM Server.
• Tower module only: Simply switch the power on to the
entire CD-ROM tower assembly containing the drives
and HP CD-ROM Server.
7. Observe the CD-ROM server’s indicator lights. They will all
flash during power-on and self-test. When the STATUS
indicator (yellow) stops flashing and remains off, the CD-ROM
server is ready for use.
Depending on the number of drives in use, this may take from
a few seconds to several minutes.
8. Insert a CD-ROM disc into a drive and verify that the ‘CD’
indicator (green) on the CD-ROM server turns on. If it does not,
verify your SCSI cable connections and addresses, then power
cycle the CD-ROM server. (If it still does not turn on, refer to
appendix A.)
Hardware installation is now completed. Proceed to chapters 3,
4, 5 and 6 to setup your CD-ROM server for use.
5
hp.book Page 10 Thursday, April 2, 1998 4:33 PM