HP Surestore NAS User Manual

Page 21

Basic Installation 2-9

Note

❏ You should refer to the documentation provided with your

CD-ROM drive. Some SCSI drives may contain special
termination instructions.

If you are installing the CD-ROM server in a tower, connect the
power connector and replace the tower enclosure.

Connecting the

CD-ROM Server to

the Network

The HP CD-ROM Server Stand-Alone Module is equipped with
RJ-45 (twisted-pair cable) and and BNC (thin coaxial cable
connectors.

The Tower Module, on the other hand, provides RJ-45 and an
AUI (Attachment Unit Interface, 15d-pin ‘D’) connectors. The
AUI connector allows you to connect to a 10Base2 (thin coax),
10Base5 (thick coax) or fiber-optic cable network using an
appropriate external transceiver.

To connect the CD-ROM server to your network follow these
steps:

Note

❏ Verify that power to the CD-ROM server is off. (For the stand-

alone module, simply disconnect the power connector.)

Connect the network cable to the appropriate connector. Use
only one of the network connectors (on the stand-alone module,
use either the RJ-45 or BNC connector)

Network connectors

Power supply
connector

RJ-45

BNC

RJ-45

AUI

4-pin Power
connector

hp.book Page 9 Thursday, April 2, 1998 4:33 PM