HP Color LaserJet 4600 Printer series - Manual (Page 65)

ENWW 51
Note The first of three sets of numbers are the default settings. If there is not
a number highlighted, a highlighted empty underscore appears.
12. Press the or arrow to to increase or decrease the number
for configuring LOCAL or DEFAULT GATEWAY .
13. Press ✔ to move to the next set of numbers.
14. Repeat steps 12 and 13 until the correct local/default gateway is
entered.
15. Press the PAUSE/RESUME button to return to the Ready state.
Disabling network protocols (optional)
By factory default, all supported network protocols are enabled.
Disabling unused protocols has the following benefits:
z decreases printer-generated network traffic
z
prevents unauthorized users from printing to the printer
z provides only pertinent information on the configuration page
z allows the printer control panel to display protocol-specific error
and warning messages
Note TCP/IP configuration cannot be disabled on the HP Color LaserJet
4600 printer.
To disable IPX/SPX
Note Do not disable this protocol if Windows 95/98, Windows NT, ME, 2000,
and XP users will be printing to the printer.
1. Press ✔ to enter the MENUS .
2. Press to highlight CONFIGURE DEVICE .
3. Press ✔ to select CONFIGURE DEVICE .
4. Press to highlight I/O .
5. Press ✔ to select I/O .
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press ✔ to select EIO X .
8. Press to highlight IPX/SPX .
9. Press ✔ to select IPX/SPX .
10. Press to highlight ON or OFF .