HP Color LaserJet 4600 Printer series - Manual (Page 49)

ENWW 35
Note The printer display dims when the printer is in PowerSave mode.
PowerSave mode does not affect printer warm-up time.
To set PowerSave Time
1. Press ✔ to enter the MENUS .
2. Press to highlight CONFIGURE DEVICE .
3. Press ✔ to select CONFIGURE DEVICE .
4. Press to highlight SYSTEM SETUP .
5. Press ✔ to select SYSTEM SETUP .
6. Press to highlight POWERSAVE TIME .
7. Press ✔ to select POWERSAVE TIME .
8. Press or to select the appropriate time period.
9. Press ✔ to set the time period.
10. Press P AUSE /R ESUME .
To disable/enable PowerSave
1. Press ✔ to enter the MENUS .
2. Press to highlight CONFIGURE DEVICE .
3. Press ✔ to select CONFIGURE DEVICE .
4. Press to highlight RESETS .
5. Press ✔ to select RESETS .
6. Press to highlight POWERSAVE .
7. Press ✔ to select POWERSAVE .
8. Press or to select ON or OFF .
9. Press ✔ to set the selection.
10. Press P AUSE /R ESUME .