HP Color LaserJet 4600 Printer series - Manual (Page 151)

ENWW 137
DISK FILE SYSTEM IS
FULL
alternates with
Ready For menus press
✔
The printer received a PJL file system
command that attempted to store
something on the file system but was
unsuccessful because the file system
is full. 1. Use the HP Web
Jetadmin software to
delete files from the EIO
disk drive and try again.
2. To remove this
message from the
display, turn the printer
off and then back on.
DISK IS WRITE
PROTECTED
alternates with
Ready For menus press
✔
The file system device is protected
and no new files can be written to it. 1. To enable writing to the
disk, turn off write
protection, using HP
Web Jetadmin.
2. To remove this
message from the
display, turn the printer
off and then back on.
Doors open. Test
aborted. A printer door has been opened
during a test. The test has been
aborted. No action necessary.
EIO DISK X
initializing The EIO disk device in slot X is
initializing. No action necessary.
EIO DISK X NOT
FUNCTIONAL For help
press
V
The EIO disk in slot X is not working
correctly. Remove the EIO disk
from the slot indicated
and replace with a new
EIO disk drive.
EIO DISK X spinning up The EIO disk device in Slot X is
spinning up its platter. No action necessary.
Event log empty SHOW EVENT LOG was selected
from the control panel, and the event
log is empty. No action necessary.
FLASH DEVICE FAILURE
alternates with
Ready For menus press
✔
A device failure has occurred on the
specified drive. 1. Printing may continue
for jobs that do not
require the Flash DIMM.
2. To remove this
message from the
display, turn the printer
off and then back on.
3. If the message persists,
remove and re-install
the Flash DIMM.
4. If the message persists,
replace the Flash
DIMM.
Flash disk X
initializing Do not
power off The new flash DIMM installed in slot
X is initializing. No action necessary.
Message Description Action