HP LaserJet 8000 Multifunction Printer series - Manual (Page 303)

Appendix B Control Panel Menus 303
I/O Menu
I/O BUFFER=AUTO AUTO
ON
OFF
Allocate memory for I/O buffering.
AUTO : The printer automatically reserves memory for I/O
buffering. Additional configurations are not required and
the
I/O BUFFER SIZE menu item does not appear.
ON : The I/O BUFFER SIZE item appears (see below). Specify
the amount of memory to be used for I/O buffering.
OFF : I/O buffering is not performed and the I/O BUFFER
SIZE item does not appear.
When the I/O buffer setting is changed, any downloaded
resources (such as fonts or macros) will need to be
downloaded again, unless they are stored on an optional
hard disk or flash DIMM.
For more information, see page
318 .
I/O BUFFER
SIZE=
100K 10K and up This item appears only when I/O BUFFER=ON . Specify the
amount of memory for I/O buffering. The maximum
amount of memory available for I/O buffering is
determined by the amount of memory installed in the
printer, the languages installed in the printer, and by other
memory allocations that must be made.
Press
- V ALUE + to change settings by increments of 10 (up
to 100 KB) or by increments of 100 (above 100 KB).
Item Values Explanation