HP LaserJet 8000 Multifunction Printer series - Manual (Page 300)

Appendix B Control Panel Menus 300
Configuration Menu
RAM DISK=OFF OFF
ON
AUTO This item determines how the RAM disk is configured.
This item appears only if there is no optional hard disk
installed and the printer has at least 12 MB of memory.
OFF : The RAM disk is disabled.
ON : The RAM disk is enabled. Configure the amount of
memory to be used through the following item: RAM DISK
SIZE .
Note
If the setting is changed from OFF to ON or from OFF to
AUTO , the printer will automatically reinitialize when it
becomes idle.
RAM DISK
SIZE=xxxK 0K and up
(This value
depends on
the amount of
installed
memory.)
This item determines the size of the RAM disk. This item
appears if
RAM DISK = ON or AUTO .
Press - V ALUE + to change settings by increments of 100.
Note
This setting cannot be changed if RAM DISK=AUTO .
Changing this value will cause the printer to reinitialize
when it becomes idle.
Item Values Explanation