HP StorageWorks 2500 Disk System - Manual (Page 58)

Figure 30 Removing a power supply
Replacing a power supply
To replace a power supply:
1. Align the power supply with the enclosure opening.
2. Lift the module latch ( Figure 31 -1) and slide the power supply into the enclosure until it is
fully seated.
3. Remove the blower from the defective power supply and install it on the replacement power
supply (see " Removing a blower " on page 58).
4. Connect the power cord to the power supply and engage the power cord lock.
5. Verify that the blower starts and the power supply/blower assembly LED is on.
Figure 31 Replacing a power supply
Removing a blower
You can replace the blower without removing the power supply.
58 Customer self repair