Installation, Preparing to install a ds2500, Unpacking the shipping carton – HP StorageWorks 2500 Disk System User Manual
Page 25: 3 installation
3 Installation
This chapter includes the following topics:
• Preparing to install a DS2500
• Unpacking the shipping carton
• Adding drives to an existing DS2500
Preparing to install a DS2500
Before installing the DS2500:
•
Ensure that electrical wiring and breakers meet the requirements described in
•
Ensure that the supported HP-UX operating software is installed on the host. See "
" on page 15 for the minimum version of supported software.
•
If you are adding to an existing storage system, ensure that the existing storage system is
operating properly before proceeding.
•
Locate a No. 2 Phillips screwdriver.
HP recommends that you remove the rack side panel for easier access.
WARNING!
A DS2500 with all components installed weighs more than 29.5 kg (65 lb.) and requires a minimum of
two people to move. To safely and easily install the DS2500, using antistatic protection remove the
drive blanks, power supply/blower assemblies, EMU, and I/O modules. This reduces the weight of
the DS2500 to approximately 11.0 kg (24 lb). Even though a single person can lift this weight, the
DS2500 is difficult to install because of its physical size. Therefore, HP recommends that a minimum of
two people install an empty DS2500 in a rack.
Unpacking the shipping carton
Inspect the contents of the shipping carton. If anything is missing or appears damaged, contact an
HP sales representative.
The carton contains:
•
DS2500 disk enclosure with disk blanks, I/O modules, EMU, and power supply/blower
assemblies
•
Two power cords
•
FC SFPs
•
HP StorageWorks 2500 Disk System read me first document
•
Snap-in rail kit
•
Eight round-hole conversion pins
•
Rack template
2500 Disk System user guide
25