Loop id (li), Enclosure id and corresponding loop ids, Table 5 – HP StorageWorks 2500 Disk System User Manual
Page 40

Table 5 Enclosure ID and corresponding loop IDs
Enclosure ID
Loop ID
1
62
2
54
3
46
4
38
5
2A
6
1C
15
0E
16
00
17
70
By default, the enclosure ID appears in the EMU alphanumeric display.
To display the En when the EMU is in another display mode:
1.
Tap the bottom push button until the alphanumeric display changes to En.
2.
Tap the top push button.
The enclosure ID appears in the alphanumeric display.
1.
Press and hold the top push button until the alphanumeric display blinks.
2.
Tap the top push button until the desired enclosure ID is displayed.
3.
Press and hold the lower push button until the alphanumeric display is En.
The updated enclosure ID appears in the alphanumeric display upon completion of the enable
procedure.
4.
Set the loop ID to correspond with the updated enclosure ID (see
Loop ID (Li)
The loop ID is a hexadecimal number that you must set to correspond with the enclosure ID. See
for the enclosure ID and loop ID pairs.
To set the loop ID:
1.
Tap the bottom push button until the alphanumeric display is Li.
2.
Tap the top push button.
The loop ID appears in the alphanumeric display.
3.
If the loop ID is set to the correct value (based on the enclosure ID), skip to
, otherwise
continue with
.
4.
Press and hold the top button until the alphanumeric display blinks.
5.
Tap the top push button until the loop ID that corresponds with the enclosure ID is displayed (see
).
TIP:
You can press and hold the top push button to scan through the numbers quickly. Release
the push button as the desired loop ID approaches, and then tap the push button until the
correct loop ID appears.
6.
To exit the loop ID display, press and release the bottom push button. The display returns to Li.
40
Using the EMU