HP StorageWorks XP Remote Web Console Software - Manual (Page 75)

Table 17 Errors during Volume Migration or Migration Cancellation by using RAID Manager
(continued)
Measure Cause Error Code
(SSB2)
Error Code
(SSB1)
Perform the volume migration after the
XP Business Copy pair is changed to the
SPLIT status. The migration source volume is a
secondary volume of an XP Business
Copy pair that is in the SP-PEND status.
This migration plan cannot be executed.
Check the configuration definition file. The migration source volume is not
installed. 2370
Perform the following measures for each
cause:
1. Recover the blocked volume, and then
migrate the volume.
2. This volume migration cannot be
executed. Check the configuration
definition file.
The migration source volume corresponds
to either of the following causes:
1. The volume is blocked.
2. The volume is the system disk.
2371
Perform the volume migration after
formatting is completed. The migration source volume is being
formatted. 2372
This volume migration cannot be
executed. Check the configuration
definition file. The migration source volume is a
command device. 2373
Release the XP Continuous Access pair,
and then perform the volume migration. The migration source volume is an
external volume specified as a primary
volume of XP Continuous Access. 237C
This migration plan cannot be executed.
Check the configuration definition file. The migration target volume is not
installed. 2380
Perform the following measures for each
cause:
1. Recover the blocked volume, and then
migrate the volume.
2. This volume migration cannot be
executed. Check the configuration
definition file.
The migration target volume corresponds
to either of the following causes:
1. The volume is blocked.
2. The volume is the system disk.
2381
Perform the volume migration after
formatting is completed. The migration target volume is being
formatted. 2382
This volume migration cannot be
executed. Check the configuration
definition file. The migration target volume is a
command device. 2383
Release the setting of Cache Residency,
and then perform the volume migration. Cache Residency is set on the migration
source volume. 2389
Release the setting of Cache Residency,
and then perform the volume migration. Cache Residency is set on the migration
target volume. 238A
This volume migration cannot be
executed. Check the configuration
definition file. The migration source volume and the
migration target volume are specified as
LUSE volumes. 238B
Cancel the reservation by XP Business
Copy, and then perform the volume
migration. The migration target volume is a reserved
volume of XP Business Copy. 238C
Make sure that the specified volume is
implemented. The pair operation command was
rejected because the specified volume is
not implemented. B911
Make sure that the specified secondary
volume is implemented. B912
Troubleshooting When Using RAID Manager 75