HP StorageWorks XP Remote Web Console Software - Manual (Page 41)

◦ If Under migration is displayed, XP Auto LUN is executing an auto migration plan.
◦ If Last migration has been canceled is displayed, XP Auto LUN has canceled the last
migration plan.
Plan Creation: Indicates when the auto migration plans were created.
Next Migration: Indicates the next time that XP Auto LUN will perform auto migration operations.
Auto Refresh: Enables you to specify whether to automate updating of information about
migration plans, which is displayed in the list.
◦ If you select Enable, information in the list will automatically be updated, so that you will
be able to check the progress of migrations in real time. If a new plan is created, the
new plan will automatically be added to the list. A message appears whenever information
in the list is updated.
◦ If you select Disable, information in the list will not automatically be updated.
NOTE: The time values displayed in this window are retrieved from the SVP, and may not
correspond to the time displayed on the Remote Web Console computer.
The list displays auto migration plans (that is, pairs of a source volume and a target volume). The
plans are executed from the top of the list when you perform an auto migration.
•
The % (percentage) column indicates the progress of the auto migration. A hyphen (-) appears
if XP Auto LUN has not executed the auto migration plan yet.
•
Source LDEV columns display information about source volumes.
LDEV indicates the volume ID in this format: LDKC:CU:LDEV. ◦
◦ Emulation indicates the emulation type of the volume.
◦ Capacity indicates the capacity of the volume.
◦ RAID indicates the RAID type.
◦ Protection indicates the data protection level.
◦ PG indicates the parity group ID. The number before the hyphen (-) is the frame number.
The number after the hyphen is the group number.
NOTE: If the indicated parity groups are the concatenated parity groups, the only parity
group ID displayed is that of the group at the top of the concatenated parity groups.
◦ HDD indicates the type of the hard disk drive.
•
Target LDEV columns display information about target volumes.
LDEV indicates the volume ID in this format: LDKC:CU:LDEV. ◦
◦ RAID indicates the RAID type.
◦ Protection indicates the data protection level.
◦ PG indicates the parity group ID. The number before the hyphen (-) is the frame number.
The number after the hyphen is the group number.
◦ HDD indicates the type of the hard disk drive.
To the right of the list are the following buttons:
•
Make New Plan button discards the existing auto migration plans and then creates new auto
migration plans.
•
Delete button deletes the auto migration plan. This button also deletes auto migration plans
below the selected plan.
•
Delete All button deletes all auto migration plans in the list.
Auto Plan Window of XP Auto LUN 41