HP StorageWorks XP Remote Web Console Software - Manual (Page 61)

The check of the disk usage rate of the parity group
including the source or target volume ended
abnormally. For the measures, call HP technical
support. Failed to check the usage rate of the source volume.
The check of the target volume ended abnormally.
For the measures, call HP technical support. Failed to check the target volume.
An unknown error occurred in checking the target
volume. For the measures, call HP technical support. An unknown error occurred in checking target
volumes.
The encryption status of the source volume is
different from that of the target volume. The volume
configuration might have been changed after the
creation of the auto migration plan. The encryption status mismatches between source
and target volumes.
C. Messages about creating auto migration plans (output when the creation started or ended)
yyyy/mm/dd hh:min The creation of auto migration plans started.
(a)
The creation of auto migration plans started.
(a) Start time
The auto migration plan XXX was created. Source = LDKC:CU:LDEV in Group X-X,
(a) (b) (c)
Target = LDKC:CU:LDEV in Group X-X
(d) (e)
The auto migration plan XXX was created.
(a) The number of the auto migration plan created
(b) Source volume
(c) Parity group of the source volume
(d) Target volume
(e) Parity group of the target volume
X auto migration plan(s) were created.
(a)
X auto migration plans were created.
(a) Number of auto migration plans
yyyy/mm/dd hh:min The creation of auto migration plans finished.
(a)
Creating auto migration plans failed.
(a) Creation end time
yyyy/mm/dd hh:min Failed to create auto migration plans. The statistics could
not be obtained.
(a)
XP Auto LUN failed to create auto migration plans because the monitoring data could not be obtained.
(a) Time when the creation of auto migration plans failed
yyyy/mm/dd hh:min Failed to create auto migration plans. Cause: XXXXXXXXXX
(a) (b)
Error location: Class X Group X-X
(c) (d)
The creation of auto migration plans failed due to the cause shown in XXXXXXXXXXXX. Perform the
appropriate measure described in (b), Cause of failure, and then create auto migration plans again.
(a) Time when the creation of auto migration plans failed
(b) Cause of failure:
Viewing the Migration History Log 61