HP StorageWorks XP Remote Web Console Software - Manual (Page 60)

yyyy/mm/dd hh:min The auto migration plan (LDKC:CU:LDEV (X-X)->LDKC:CU:LDEV
(X-X)) was
(a) (b) (c) (d) (e)
canceled because of invalid parity group information.
The auto migration plan (LDKC:CU:LDEV (X-X)->LDKC:CU:LDEV (X-X)) was canceled because the specified
parity group information is incorrect. The correspondence between the source or target volume and the
parity group is invalid. That volume might have been migrated manually after the creation of the auto
migration plan.
(a) Canceled time
(b) Source volume
(c) Parity group of the source volume
(d) Target volume
(e) Parity group of the target volume
yyyy/mm/dd hh:min The auto migration plan (LDKC:CU:LDEV->LDKC:CU:LDEV) was
stopped.
(a) (b) (c)
Cause: XXXXXXXXXXXX
(d)
The execution of the auto migration plan (LDKC:CU:LDEV->LDKC:CU:LDEV) was stopped due to the cause
shown in XXXXXXXXXXXX. The status of the volumes returned to the status before the migration. This auto
migration plan is not valid. If necessary, create auto migration plans again.
(a) Stopped time
(b) Source volume
(c) Target volume
(d) Cause of stop:
The specified target volume is not a reserved
volume. This volume was changed to a normal
volume after the creation of the auto migration plan. The specified target volume is not the reserved
volume.
The emulation type of the source volume is different
from that of the target volume. The volume
configuration might have been changed after the
creation of the auto migration plan. The emulation type mismatches between source
and target volumes.
The disk usage rate of the parity group including
the source or target volume is over the specified
limit. Or, the disk usage rate of the parity group
including the source or target volume is unknown
because no monitoring data exists about them.
If necessary, change the limit of the disk usage rate
and create auto migration plans again. You can
change the limit at Max. disk utilization in Auto
Plan Parameters of the Auto Plan window.
The usage rate of the source volume is over the
specified max disk utilization, or the usage rate is
unknown.
Failed to migrate the volume due to an error
indicated by Error code XXXXXXXX. The error code
is displayed in the format 5205-XXXXXXXX. 5205
indicates the part code of XP Auto LUN. For details
about the error, see the HP StorageWorks
XP24000/XP20000 Remote Web Console Error
Codes. The migration failed. Error code: XXXXXXXX.
The size of the source volume is different from that
of the target volume. The volume configuration
might have been changed after the creation of the
auto migration plan. The volume size mismatches between source and
target volumes.
The emulation type of the specified target volume
is not supported. The volume configuration might
have been changed after the creation of the auto
migration plan. Unsupported emulation type
60 XP Auto LUN Operations