HP StorageWorks XP Remote Web Console Software - Manual (Page 63)

In Group X-X, there are X invalid samples. These samples were not used for
creating the auto
(a) (b)
migration plans.
There are some invalid samples in the parity group X-X. Therefore, XP Auto LUN created auto migration
plans without using these samples. (If there is one invalid sample, this message is shown as ... there is
invalid sample. This sample was ...)
(a) Parity group
(b) Number of invalid samples
There is too much invalid data in Group X-X LDKC:CU:LDEV.
(a) (b)
All the data about the volume were not used for creating the auto migration
plans.
There is too much invalid data in volume LDKC:CU:LDEV of the parity group X-X. Therefore, XP Auto LUN
created auto migration plans without using this volume.
(a) Parity group
(b) Volume
yyyy/mm/dd hh:min The creation of auto migration plans has already been
started.
(a)
XP Auto LUN has already started the creation of auto migration plans.
(a) Creation start time
D. Messages about creating each auto migration plan (output during the creation)
yyyy/mm/dd hh:min Source candidate = LDKC:CU:LDEV in Group X-X
(a) (b) (c)
target candidate = LDKC:CU:LDEV n Group X-X XXXXXXXXXXXX
(d) (e) (f)
XP Auto LUN found a proper candidate for the target volume corresponding to the specified candidate
for the source volume.
(a) Start time of creating this auto migration plan
(b) Candidate for the source volume
(c) Parity group of the candidate for the source volume
(d) Candidate for the target volume
(e) Parity group of the candidate for the target volume
(f) Migration type
Migrates the volume to a parity group in a higher
HDD class Auto migration of a volume to a higher HDD class
Migrates the volume to a parity group in a lower
HDD class Auto migration of a volume to a lower HDD class
Migrates the volume to a parity group in the same
HDD class Auto migration of a volume in the same HDD class
Viewing the Migration History Log 63