HP StorageWorks XP Remote Web Console Software - Manual (Page 72)

Table 17 Errors during Volume Migration or Migration Cancellation by using RAID Manager
(continued)
Measure Cause Error Code
(SSB2)
Error Code
(SSB1)
Migration is not allowed between the
normal volume specified as a LUSE
volume and the XP Thin Provisioning
virtual volume.
Release the XP Continuous Access
Asynchronous pair, and then perform the
volume migration. The migration source volume is used in
an XP Continuous Access Asynchronous
pair. The CLPR of the migration source
volume and the CLPR of the migration
target volume are mismatched. 20A1
Wait until the capacity increase is
completed. Then, you must specify a
migration target volume that has the
same capacity as the volume whose
capacity is increased, and perform the
volume migration operation. The migration source volume is an XP
Thin Provisioning virtual volume whose
capacity is increasing. 20A5
Wait until the capacity increase is
completed. Then, you must specify a
migration source volume that has the
same capacity as the volume whose
capacity is increased, and perform the
volume migration operation. The migration target volume is an XP Thin
Provisioning virtual volume whose
capacity is increasing. 20A6
Wait until the discarding zero data of
the XP Thin Provisioning virtual volume
finishes, and then perform the volume
migration. The migration source volume is an XP
Thin Provisioning virtual volume in which
the zero data is being discarded. 20AD
Wait until the discarding zero data of
the XP Thin Provisioning virtual volume
finishes, and then perform the volume
migration. The migration target volume is an XP Thin
Provisioning virtual volume in which the
zero data is being discarded. 20AE
Release the pair of FlashCopy Mirroring
V2, and then migrate the volume. The migration source volume is the
primary or secondary volume of
FlashCopy Mirroring V2. 22FA
Release the pair of FlashCopy Mirroring
V2, and then migrate the volume. The migration target volume is the
primary or secondary volume of
FlashCopy Mirroring V2. 22FB
Install XP Auto LUN, and then perform
the volume migration. XP Auto LUN is not installed on the
storage system. 2301
Check the configuration information of
your storage system. The shared memory that is necessary to
use XP Auto LUN is not installed or the
initial setting is not completed. 2302
This volume migration cannot be
executed. Check the configuration
definition file. The LBA size does not match between
the migration target volume and the
migration source volume. 2306
Reduce the number of pairs set in the
storage system, and then perform the
volume migration. The maximum number of pairs that can
be set in the storage system is exceeded. 2309
Cancel the reservation by XP Auto LUN,
and then perform the volume migration. The migration target volume is already
reserved by XP Auto LUN. 2311
Make the migration source volume offline
from the host, and then perform the
volume migration. The migration source volume is online
with the host. 2312
72 Troubleshooting