HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 6)

Introduction 6
Introduction
What's new
The command line interface user guide contains the following changes for VC 3.30:
• Added support for IGMP v3 snooping
• Added the Nags property to the add network and set network commands
• Added the Nag property to the add profile and set profile commands
• Added the copy subcommand to the profile managed element
• Modified the set enet-vlan command to allow mapped and tunneled networks in the same domain
• Modified the show network command output:
o Configured values for ConnectionMode and VLanTunnel display for UNSHARED networks only
o Configured values for NativeVLAN, UplinkSet, and VLanID display for SHARED networks only
• Enhanced the show uplinkport and show server-port command outputs to display the cause
of an unlinked port with no connectivity
For more information, see "Port status conditions (on page
152 )."
• Added the add and set subcommands to the interconnect managed element
• Added the copy subcommand to the uplinkset managed element
• For the following commands, where one of the parameters is a URL, a new syntax is supported to
contain the IP address, port number, and filename as a single string:
o load ldap-certificate
o load ssl-certificate
o save ssl-csr
o load ssh
o save supportinfo
o save profile
o load profile
The old syntax for these commands, where filename is a separate property, is still supported.
• New managed elements:
o banner (on page 20 )
o config (on page 21 )
o configbackup (on page 22 )
o igmp-group (on page 42 )
o interconnect-mac-table (on page 45 )
o lldp (on page 55 )