HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 41)

Command line 41
Item Description
increments.
CustomSpeed (required
if the SpeedType is
Custom)
The user-defined speed for the server port. Valid values include 100Mb to
10Gb configured in 100Mb increments.
BootPriority
(optional)
Controls whether the FCoE HBA port is enabled for SAN boot and affects the
BIOS boot order. Valid values include "BIOS", "Primary", "Secondary", and
"Disabled".
BootPort
(Required if the Boot Priority is
either Primary or
Secondary)
The target WWPN of the controller interface on the Fibre Channel storage
target. The port name is a 64-bit identifier in the format
NN:NN:NN:NN:NN:NN:NN:NN, where N is a hexadecimal number.
BootLun
(Required if the Boot Priority is
either Primary or
Secondary)
The LUN of the volume used for SAN boot. Valid values include an integer from
0 to 255 or 16 hex digits (HP-UX only).
Examples
->set fcoe-connection MyProfile:1 Fabric=SAN_5
Changes the fabric of an FCoE SAN fabric connection
->set fcoe-connection RedProfile:2 Fabric=""
Sets a FCoE SAN fabric connection to "Unassigned"
->set fcoe-connection MyProfile:1 SpeedType=Custom
CustomSpeed=5000
Modifies the FCoE connection and sets a custom speed of 5Gb
->set fcoe-connection BlueProfile:1 BootPriority=Primary
BootPort=50:06:0B:00:00:C2:62:00 BootLun=5
Changes the SAN boot priority and sets additional boot parameters
Item Description
show fcoe-connection Display the FCoE connections associated with the server profiles.
Syntax
show fcoe-connection []
Parameter
ConnectionID
(optional)
The ID of an existing FCoE connection. The ID format is .
Use to display all FCoE connections of a profile. Use "*" to
display all FCoE connections in the domain.
Examples
->show fcoe-connection
Displays all FCoE connections in the domain
->show fcoe-connection Profile1:*
Displays all FCoE connections of a profile named Profile1
->show fcoe-connection Profile1:1
Displays a specific FCoE connection of a profile named Profile1