HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 86)

Command line 86
Item Description
severities can be specified, separated by commas. The default severity is "None".
DomainCategories The Virtual Connect domain trap categories to send to the destination. Valid values
are "Legacy", "DomainStatus", "NetworkStatus", "FabricStatus", "ProfileStatus",
"ServerStatus", "EnetStatus", FcStatus", "All", and "None". Multiple categories can
be specified, separated by commas.
EnetCategories The Virtual Connect Ethernet trap categories to send to the destination. Valid values
are "PortStatus", "PortThreshold", "Other", "All", and "None". Multiple categories
can be specified, separated by commas.
FcCategories The Virtual Connect Fibre Channel trap categories to send to the destination. Valid
values are "PortStatus", "Other", "All", and "None". Multiple categories can be
specified, separated by commas.
Examples
->add snmp-trap EnetManagementStation Address=192.112.34.10
Community=private Format=SNMPv1 Severity=Normal,Critical
EnetCategories=Other
Adds a new trap destination for VC-Enet modules
->add snmp-trap FcManagementStation Address=192.112.72.3
Community=private Format=SNMPv1 FcCategories=Other
Adds a new trap destination for VC-FC modules
->add snmp-trap MyTrap Address=192.112.66.12
Adds a new trap using typical defaults
->add snmp-trap MyTrap Address=192.112.42.5 Severity=All
FcCategories=All DomainCategories=All
Adds a trap with all severity and category properties set. Severities are allowed
even though FC categories are set, but the severities are applied to the domain
categories.
Item Description
remove snmp-trap Removes a previously configured SNMP trap destination.
Syntax
remove snmp-trap
Parameter
Name (required) The name of the trap destination to be removed. Use "*" to remove all traps.
Examples
->remove snmp-trap MyTrap1
Removes an SNMP trap destination
->remove snmp-trap *
Removes all configured SNMP trap destinations
Item Description
set snmp-trap Modifies an existing SNMP trap destination.
Syntax
set snmp-trap [Name=
name>][Address=] [Community=
name string>][Format=][Severity=
severity | All|None>][DomainCategories=
| All|None>][EnetCategories=
All|None>][FcCategories=]
Parameter
TrapName (required) The name of the trap to be modified
Properties
Name New name of the trap.
Address (required) IPv4 address or DNS name for the trap destination.